.25 oz. - Fingerprint Re-hydration Ridge Builder Solution
Ready Ridge Fingerprint Rehydration Solution produces better ridge
detail for the fingerprinting of both living and deceased individuals
with faster results using a patent-pending rehydration technology
developed by KDL Solutions. Ready Ridge is a clear, odorless, non-toxic,
and completely non-volatile solution. It may be heated to achieve even
better results.
For the deceased, Ready Ridge Fingerprint Rehydration Solution acts
as both a soaking agent and an injectable tissue rehydration fluid for
mummified friction ridge skin. For the living, Ready Ridge Fingerprint
Rehydration Solution acts as a non-toxic topical solution for
application directly to the fingerprint ridge detail of living subjects.
There is no need (and it should never be attempted) to inject Ready
Ridge into living subjects.
A simple spray of Ready Ridge provides quick and effortless ridge
detail improvement for all your fingerprinting needs. Simply spray the
solution onto the subject's hands prior to fingerprinting. The subject
should rub the solution over the intended ridge detail and sufficient
time should be allowed for the solution to absorb into the skin tissue
(absorption time is dependent on existing tissue hydration levels.
Protocol-A (Soaking Fingerprints)
1. Designated finger should be cleaned thoroughly with 70% alcohol (rubbing alcohol) or mild soap and water.
2. Dry designated finger with clean gauze or paper towel. *Not included in kit
3.
Soak desired finger in KDL Rehydration solution for 15 minutes. Place
soaker filled container on warmer. Solution takes about 10-15 minutes to
warm. If finger is extremely dehydrated soak an extra 15 minutes.
(procedure should take no longer than 30 minutes)
4. After finger has soaked, wipe off excess solution with clean gauze or paper towel.
5. Finger is ready for printing process. Protocol-B (Injecting Solution into Fingertip) Only Use This Technique With Cadavers
1. Designated finger should be thoroughly cleaned with 70% alcohol.
2. Syringe up desired amount of solution.
*Expert tip: use a soaker container and warm a small amount of solution for 10-15 minutes.
3. Inject solution on the side of fingertip.
*Expert tip: inject solution
slowly
about 1cc at a time----pause----don’t be alarmed, some solution may
come out that is normal, continue to inject more solution in the same
area or opposite side of the fingertip.
4. As Fingertip is starting to relax at this point skin is rehydrating, normally this takes about 15 to 30 minutes.
5. Wipe fingertip with clean gauze or paper towel.
6. Finger is ready for printing process
Protocol-C (Misting Rehydration Spray)
1. Clean designated finger with 70% alcohol.
2. Dry designated finger with clean gauze or paper towel.
3. Mist designated finger thoroughly.
4. Press finger on clean gauze lightly or paper towel (gentle enough to rid of rehydration residue.)
5. Finger is ready for print or scanning process.
Limitations and warranty:
There
are no warranties, expressed or implied. KDL Solutions is not liable
for personal damage or personal injury caused by this product.