The Insta Mark 126
Orders can take up to 4-5 weeks.
The Mark 126 is our most popular model. It is excellent for all inspection marking on nonporous surfaces.
Our new casing design dramatically improves the soft-touch application, for permanent and readable marks.
The Insta Mark 126 has a .375 maximum diameter print area. You may choose from our standard 1/4” or 3/8” diameter symbols (see below) or you may customize any configuration you need.
This stamp maybe used with the Auto Marker
Multiple borders to choose from.
Colors Available: Black, Blue, Red, Green, Purple, White, and Ultraviolet (ink can be
used on equipment or hands).
IMPORTANT NOTE; Stamp comes with a fast drying ink and you will need to order re-inking fluid.
Orders can take up to 4-5 weeks.
Any questions call 714-979-1405 or email us at Sales@HittMarking.com
Insta Mark 126 Instructions
Directions For Use:
Always use resealable bag for storage
Proper care of the Insta Mark 126 will give you clean, consistent
impressions every time. Make certain to follow these instructions
carefully.
1. How Often Should the Insta Mark be re-inked? The Insta Mark 116
should be re-inked approximately every 1,000 marks. It is important not
to run the stamp completely dry. By adding the appropriate number of
drops (5-6) every 1,000 marks you will be able to keep the stamp moist and
in condition to handle high volume marking or long term storage.
2. Use ONLY Insta Mark 126 Ink. The chemical composition of your
Insta Mark may be jeopardized with the use of any other ink. Swelling and
distortion may occur.
3. Do not leave Insta Mark cap off for extended period of time. Do not
use stamp pad.
4. Do not clean! The Insta Mark die will remain moist. Therefore,
layers of dried ink will not accumulate. Cleaning is not necessary. Do
not rub or allow the impression surface to come in contact with sharp
objects. However, should the die face become dusty or dirty you may take a
piece of clear scotch tape and gently place it on the stamp surface. Rub
your finger three or four times across scotch tape. Then, gently remove
tape from stamp face. Repeat if necessary.
5. Press gently. A hard strike is not necessary. By stamping
softly a minimum amount of ink will be transferred and the drying time will
be decreased. If the stamp is making a heavy ink mark, follow re-inking
instruction step # 3 below. (Adjusting Pressure Insert)
6. Replace cap. Do not allow your Insta Mark to remain uncapped for
over 3-5 minutes at one time. Fast dry inks evaporate quickly. If the
rubber die begins to dry or the mark becomes light, recap tightly and put
the Insta Mark aside for 15-30 minutes. If the ink does not regenerate,
follow the re-inking instructions. (See Below)
For clean impressions with excellent adhesion - do not stamp on wet or
greasy surfaces. We recommend wiping the surface clean with Re-activator.
After removing your Printed Circuit Board, or other material, from a de-greasing bath - let the solvent evaporate before touching the mark (this
should take about 2-3 seconds). The mark will then remain permanent.
Warning: Keep out of the reach of children. Avoid skin
contact. If skin contact is made, wash the affected area with soap and
water.